免费看的黄色,在线观看日批,在线91?看

Working principle and installation of IMPRESIND gas radiant heating system

time：2023-09-27
hits：1304次
source：正弘奧能

IMPRESIND gas radiation heating system is an independent suspended gas radiation system, the heat source is natural gas or liquefied petroleum gas, by generators, special radiation pipe sections of the heating distribution system. The generator housing is made of stainless steel and houses the combustion assembly, ventilation assembly, distribution control and safety mechanism. 
 

	Heat generation is mainly achieved through generators, which are factory tested and pre-adjusted, assisted by safety and command systems. The fan brings the entire radiant tube system to negative pressure to extract the air necessary for combustion, recover the combustion products (even the tube temperature) and exhaust the smoke through the exhaust tube. The combustion system is continuously controlled by an electronic control device each time the fan is started for heating, to ensure the air pressure of the radiation circuit, the ignition situation, to ensure the correct state of the flame, and to stop the burning gas immediately in case of an anomaly and place it in a safe area. In addition, electronic data acquisition is achieved through a black ball sensor placed in the heating environment, which in turn manages the different stages of combustion according to parameter Settings and working hours to control the temperature.


	 


	<img src="http://www.flhyjz.com/Uploads/image/20230927/20230927143417_74805.jpg" alt="" /> 

 
The radiation section is composed of a series of modules (ranging from 2 to 4 meters), each module is made of a special aluminized steel pipe and is connected together by the corresponding bracket inserted into the module. The side panels are specially made aluminum insulation panels with high reflective power. The main structure is a coated composite steel plate that supports and accommodates all components of the radiation tube section. Steel pipes are connected with special joints. It has special high temperature resistance and elasticity, and is connected to the radiation tube section by a ring hook to keep the position fixed. The solution, which does not use sealing compounds or putty, compensates for the expansion caused by the heating of the modules, so that they do not cause dangerous expansion and stretching, providing a guarantee of long-term sustainable use. 
 

	The gas radiant heating system is equipped with stainless steel suspension brackets for complete internal or external installation. The radiation tube needs to be mounted on the interior of the building, the ceiling or other structures, and the radiation section is suspended by a regular chain (one suspension point every 4 meters from the generator). The generator shall be installed using the provided suspension bracket. Do not place the generator directly on the roof or floor. The generator should be at least 50 cm away from the wall, depending on the climate of the installation site (snow should be taken into account). There are openings at the bottom of the generator to allow gas to enter, unstoppably or reduce the openings, they are an essential part of the correct operation of the equipment.


	 


	<img src="http://www.flhyjz.com/Uploads/image/20230927/20230927143436_18970.jpg" alt="" /> 

 
According to the wall structure and the weight of the generator, select the correct tension bolt and cut holes in the wall (it is recommended to use a 12mm diameter tension bolt through the wall and bolt it from one side of the inner wall). The outer box is firmly fixed on the wall, and the contact place between the box and the external wall is sealed with sealant to prevent water seepage.

老师脱了内裤让我爽了一夜_三上悠亚av影院在线看_亚洲第一AV五码免费一区_99热热久久_一区二区久久久久久_手机黄网www8xcn

Working principle and installation of IMPRESIND gas radiant heating system